Repair procedures: Removal

WARNING:

DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the camshaft position sensor connector (A).
Remove the installation bolt (B), and then vertically remove the sensor from the cylinder head.

Bank 1/Intake

Fig 1: Camshaft Position Sensor Connector - Bank 1/Intake

Courtesy of HYUNDAI MOTOR AMERICA

Bank 1/Exhaust

Fig 2: Camshaft Position Sensor Connector - Bank 1/Exhaust

Courtesy of HYUNDAI MOTOR AMERICA

Bank 2/Intake

Fig 3: Camshaft Position Sensor Connector - Bank 2/Intake

Courtesy of HYUNDAI MOTOR AMERICA

Bank 2/Exhaust

Fig 4: Camshaft Position Sensor Connector - Bank 2/Exhaust

Courtesy of HYUNDAI MOTOR AMERICA