Repair Procedures: Removal

1. Perform "Neutral Mode" procedure with GDS. (Refer to "IMMOBILIZER SYSTEM " in BE article).
2. Insert the Key and turn it to the IGN ON and OFF position. Then the ECM Key register process is completed automatically.

[In the Case of Installing New ECM] 

• Insert the key and turn it to the IGN ON and OFF position.

Then the ECM key register process is completed automatically.

1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
2. Remove the air cleaner assembly.

   (Refer to Engine Mechanical System - "AIR CLEANER 1.6L ")

3. Disconnect the ECM Connector (A).
   Fig 1: Disconnecting ECM Connector

   Courtesy of HYUNDAI MOTOR AMERICA
4. Remove the mounting bolt (A) and nuts (B), and then remove the ECM (C).
   Fig 2: Removing ECM Mounting Bolt And Nuts

   Courtesy of HYUNDAI MOTOR AMERICA
5. Remove the ECM (B) after removing 4 nuts (A) from the bracket.

Fig 3: Removing ECM Bracket Assembly

Courtesy of HYUNDAI MOTOR AMERICA