LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2016 >> Veloster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Disc Brake System) >> Rear Disc Brake >> Repair Procedures >> Inspection >> Rear Brake Disc Runout Check
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Rear Brake Disc Runout Check

WARNING: This page is about a different car, the 2015 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a Dial Gauge about 5mm (0.2 in.) from the Outer Circumference of the Brake Disc and measure the Runout of the Disc.

    Brake Disc Runout 

    Limit: 0.03 mm (0.0012 in.) or less (New One)

    Fig 1: Measuring Disc Runout
    G10605119Courtesy of HYUNDAI MOTOR AMERICA
  2. If the Runout of the Brake Disc exceeds the limit Specification, replace the disc, then measure the Runout again.
  3. If the Runout exceeds the limit Specification, install the Brake Disc after turning it 180° and then check the Runout of the Brake Disc Again.
  4. If the Runout cannot be corrected by changing the position of the Brake Disc, replace the Brake Disc.
scientia non olet · About LEMON Manuals