Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.

Perform the oil pressure characteristics backup procedure using the GDS when replacing with a new TCM.

Fig 1: Scantool Display - Oil Pressure Characteristics Backup Procedure (1 Of 3)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Scantool Display - Oil Pressure Characteristics Backup Procedure (2 Of 3)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 3: Scantool Display - Oil Pressure Characteristics Backup Procedure (3 Of 3)
Courtesy of HYUNDAI MOTOR AMERICA
Turn ignition switch OFF.
Disconnect the negative (-) battery cable.
Disconnect the TCM Connector (A).

Fig 4: Locating TCM Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the battery.
(Refer to Engine Electrical System - "BATTERY ")
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "AIR CLEANER ")
Remove the mounting bolts (A) and nut (B), and then remove the TCM (C).

Fig 5: Locating TCM, Mounting Bolts And Nut
Courtesy of HYUNDAI MOTOR AMERICA
After removing the installation nuts (A) and screws (B), remove the TCM from the bracket.

Fig 6: Locating TCM Installation Nuts And Screws
Courtesy of HYUNDAI MOTOR AMERICA