LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2017 >> Accent Value Edition >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Engine Control System - 2.0L) >> Injector >> Repair Procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Combustion Seal, Rubber Washer, Support Disc And O-Ring
G12055451Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
  • Do not reuse the used injector fixing clip.
  • Install the component with the specified torques.
  • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  • Apply engine oil to the injector O-ring.
  • Do not reuse the used injector O-ring.
  • Do not reuse the used bolt.
  • When inserting the injector, be careful not to damage the injector tip.
CAUTION:
  • Do not reuse the support disc.
  • Do not reuse the injector rubber washer.
  • When replacing the rubber washer, the steal plate (A) part should be faced the cylinder installation part and the rubber plate (B) part should be faced the injector body part.
Fig 2: Locating Steal Plate
G12055452Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
  • Do not reuse the combustion seal.
CAUTION:
  • When tightening the delivery pipe installation bolts, tighten them in accordance with the order ((2)→ (3)→ (1)→ (4)) after tightening with hand-screwed torque.
Fig 3: Delivery Pipe Bolts Tightening Sequence
G12055453Courtesy of HYUNDAI MOTOR AMERICA
  1. Installation is reverse of removal.
scientia non olet · About LEMON Manuals