Repair Procedures: Removal

Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Remove the air cleaner.
(Refer to Engine Mechanical System - "AIR CLEANER ")
Remove the wiring bracket (A) after releasing the fixing hooks (B).

Fig 1: Locating Wiring Bracket And Fixing Hooks
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the engine coolant temperature sensor connector (A).
Remove the fixing clip (B),
Remove the engine coolant temperature sensor.

Fig 2: Locating Engine Coolant Temperature Sensor Connector And Fixing Clip
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Note that engine coolant may flow out from the water temperature control assembly when removing the sensor.
Fill with engine coolant.
(Refer to Engine Mechanical System - "COOLANT ")