Repair Procedures: Removal

Remove the floor console.
(Refer to "FLOOR CONSOLE ASSEMBLY ").
Disconnect the connector (A).

Fig 1: Disconnecting Connector
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the shift control cable (A).

Fig 2: Disconnecting Shift Control Cable
Courtesy of HYUNDAI MOTOR AMERICA
Remove the AT lever (shift lever) assembly (A) by removing the bolts (4ea).
Tightening torque :

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Fig 3: Removing AT Lever (Shift Lever) Assembly Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.

NOTE: Make sure vehicle does not roll before setting room side shift lever and Automatic Transaxle (AT) side.