Repair Procedures: Removal

Disconnect the negative (-) battery cable.
Remove the air cleaner assembly and air duct.
(Refer to "AIR CLEANER ").
Remove the under cover (A).
Tightening torque :

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft))

Fig 1: Removing Under Cover
Courtesy of HYUNDAI MOTOR AMERICA
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to "FLUID ").
Remove the air breather hose (A).
Remove the valve body cover (B).
Tightening torque :

13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.8 ~ 11.6 lb-ft)

Fig 2: Removing Air Breather Hose
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the oil temperature sensor connector (A).

Fig 3: Disconnecting Oil Temperature Sensor Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the oil temperature sensor (A) after removing a bolt.
Tightening torque :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 4: Removing Oil Temperature Sensor Bolt

Courtesy of HYUNDAI MOTOR AMERICA