Repair Procedures: Installation

Check that the shift lever is placed in the "N" position.
Lightly tighten the bolts (A) after installing the inhibitor switch.
Lightly tighten the nut (B) after installing the manual control lever.

Fig 1: Installing Manual Control Lever/Washer And Inhibitor Switch Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Align the hole in the manual control lever with the "N" position hole of the inhibitor switch and then insert the inhibitor switch guide pin (SST No.: 09480-A3800).
Tighten the nut (A) and bolts (B) with the specified torque.
Tightening torque
1. 17.7 - 24.5 N.m (1.8 - 2.5 kgf.m, 13.0 - 18.1 lb-ft)
2. 9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
Fig 2: Inserting Inhibitor Switch Guide Pin Using (SST No. 09480-A3800)
Courtesy of HYUNDAI MOTOR AMERICA
Lightly tighten the nut (A) after connected the shift cable (B) in the manual control lever (C).
Push nut (A) lightly to "F" direction shown in (Fig 3) to eliminate free play of shift cable.
Tighten the nut (A) with the specified torque.
Tightening torque:

9.8 - 13.7 N.m (1.0 - 1.4 kgf.m, 7.2 - 10.1 lb-ft)

Fig 3: Connecting Shift Cable, Manual Control Lever And Nut
Courtesy of HYUNDAI MOTOR AMERICA
Remove the inhibitor switch guide pin (SST No.: 09480-A3800) from the hole.
Connect the inhibitor switch connector (A).

Fig 4: Connecting Inhibitor Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Install the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "AIR CLEANER ")
Connect the battery negative (-) cable.
Check that operating surely at each range of the inhibitor switch corresponding to each position of shift lever.