Repair Procedures: Installation

Install the shift cable retainer (A).
Tightening torque:

11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

Fig 1: Installing Shift Cable Retainer
Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- Install the cable after placing the shift lever and the manual control lever in the N position.
Install the shift cable (A) in the shifter lever.

Fig 2: Installing Shift Cable In Shifter Lever
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Lug (A) must assemble upward.
  
  Fig 3: Locating Lug
  Courtesy of HYUNDAI MOTOR AMERICA
- Bending area (A) must assemble the front.
  
  Fig 4: Locating Bending Area
  Courtesy of HYUNDAI MOTOR AMERICA
- Push in the cable socket at bracket of AT lever and must confirm that assembly sound and portion (A) of sock protrude from cap of socket.
  - Portion (A) located inside the cap before assembled.
  - Portion (A) must protrude after socket assembled.
  Fig 5: Locating Portion Inside Cap
  Courtesy of HYUNDAI MOTOR AMERICA
Install the shift cable (B) in the cable bracket (C).
Align the hole (E) in the manual control lever with the "N" position hole (F) of the inhibitor switch and then insert the inhibitor switch guide pin (SST No: 09480-A3800).
Lightly tighten the nut (A) after connected the shift cable (B) in the manual control lever (D).
Push shift cable (B) lightly to "F" direction shown in (Fig 6) to eliminate free play of shift cable.
Tighten the nut (A) to the specified torque.
Tightening torque:

9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)

Fig 6: Inserting Inhibitor Switch Guide Pin Using (SST No. 09480-A3800)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the inhibitor switch guide pin (SST No.: 09480-A3800) from the hole.
Install the floor console assembly.
(Refer to Body - "FLOOR CONSOLE ")
Install the air cleaner assembly.
(Refer to Engine Mechanical System - "AIR CLEANER ")
Install the battery and battery tray.
(Refer to Engine Electrical System - "BATTERY ")
Install the air duct.
(Refer to Engine Mechanical System - "AIR CLEANER ")
Check that operating surely at each range of the inhibitor switch corresponding to each position of shift lever.