LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2017 >> Santa Fe Sport 2.0T, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 2.0L >> Variable Charge Motion Actuator (VCMA) >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

  1. Turn the ignition switch off and disconnect the battery (-) terminal.
  2. Remove the RCV control solenoid valve.

    (Refer to Engine Control System - "RCV CONTROL SOLENOID VALVE ")

  3. Remove the purge control solenoid valve.

    (Refer to Engine Control System - "PURGE CONTROL SOLENOID VALVE ")

  4. Disconnect the variable charge motion actuator connector (A).
  5. Remove the variable charge motion actuator mounting bolts (B).
    Fig 1: Disconnecting Variable Charge Motion Actuator Connector
    G12055473Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove VCMA rod clip (A) and connection link between flap (B) using screwdriver.
    Fig 2: Removing VCMA Rod Clip
    G12055474Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • VCMA connection link can be damaged. So, make sure to remove it in a horizontal direction.
    • Make sure that groove part of the connection link (C) is pointing upward when mounting VCMA.
    Fig 3: Locating Groove Part Of Connection Link
    G12055475Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals