Repair Procedures: Removal

Remove the battery and the battery tray.
(Refer to Engine Electrical System - "BATTERY ")
Remove the under cover (A).
Tightening torque:

7.8~11.8N.m (0.8 ~ 1.2 kgf.m, 5.8~8.7 lb-ft)

Fig 1: Removing Under Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.
Drain plug tightening torque:

38.2 ~ 48.1 N.m (3.9 ~ 4.9 kgf.m, 28.2 ~ 35.4 lb-ft)

Fig 2: Removing Drain Plug
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: Replace the gasket before reinstalling the drain plug.
Remove the wiring bracket installation bolt (A).

Fig 3: Removing Wiring Bracket Installation Bolt
Courtesy of HYUNDAI MOTOR AMERICA
Remove the ATF Injection hole (eyebolt) (A).
Eyebolt tightening torque:

2.9 ~ 4.9 N.m (0.3 ~ 0.5 kgf.m, 2.2 ~ 3.6 lb-ft)

Fig 4: Removing ATF Injection Hole (Eyebolt)
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: Replace the O-Ring (A) before reinstalling the eyebolt.

Fig 5: Locating O-Ring Eyebolt
Courtesy of HYUNDAI MOTOR AMERICA
Remove the valve body cover (A).
Tightening torque:

(A) 13.7~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.1 ~ 11.6 lb-ft)

Fig 6: Removing Valve Body Cover
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Replace the gasket (A) before reinstalling the valve body cover.
Fig 7: Replacing Gasket And Valve Body Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the oil temperature sensor connector (A).

Fig 8: Disconnecting Oil Temperature Sensor Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the oil temperature sensor (A) after removing a bolt.
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

CAUTION: Be careful not to damage the harness lock connector.

Fig 9: Removing Oil Temperature Sensor
Courtesy of HYUNDAI MOTOR AMERICA