Repair Procedures: Removal

[Bank 1/Sensor 1] 

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Disconnect the connector (A), and then remove the sensor (B).

Fig 1: Locating SST (Part No.: 09392-1Y100)

Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Locating Heated Oxygen Sensor And Connector (Bank 1/Sensor 1)

Courtesy of HYUNDAI MOTOR AMERICA

[Bank 1/Sensor 2] 

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Disconnect the connector (A), and then remove the sensor (B).

Fig 3: Locating Heated Oxygen Sensor Connector (Bank 1/Sensor 2)

Courtesy of HYUNDAI MOTOR AMERICA

Fig 4: Locating Heated Oxygen Sensor (Bank 1/Sensor 2)

Courtesy of HYUNDAI MOTOR AMERICA