Repair Procedures: Installation

1. Install the retainer and then tighten the nut (A).

   Tightening torque: 

   8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

   Fig 1: Locating Retainer Nuts

   Courtesy of HYUNDAI MOTOR AMERICA
2. Install the shift cable (A) and then fix the snap pin (B).
   NOTE:

   • Install the cable after placing the shift lever and the manual control lever in the N position.
   Fig 2: Installing Shift Cable

   Courtesy of HYUNDAI MOTOR AMERICA
3. Align the hole (A) in the manual control lever with the "N" position hole (B) of the inhibitor switch and then insert the inhibitor switch guide pin (SST No: 09480-A3800).
   Fig 3: Inserting Inhibitor Switch Guide Pin (SST No.:09480-A3800)

   Courtesy of HYUNDAI MOTOR AMERICA
4. Connect the shift cable (C) into cable bracket (A).
5. Lightly tighten the nut (B) after connected the shift cable (C) in the manual control lever (D).
6. Push shift cable (C) lightly to "F" direction shown to eliminate free play of shift cable.
7. Tighten the nut (B) to the specified torque.

   Tightening torque: 

   9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)

   Fig 4: Pushing Shift Cable

   Courtesy of HYUNDAI MOTOR AMERICA
8. Install the battery and tray.

   (Refer to Engine Electrical System - "BATTERY ")

9. Install the TCM.

   (Refer to Dual Clutch Transmission Control System - "TCM ")

10. Install the air cleaner assembly and air duct.

(Refer to Engine Mechanical System - "AIR CLEANER ")