Repair Procedures: Installation

1. Check that the shift lever is placed in the "N" position.
2. Lightly tighten the inhibitor switch mounting bolts (B) after installing the inhibitor switch (A).
   Fig 1: Locating Inhibitor Switch And Mounting Bolts

   Courtesy of HYUNDAI MOTOR AMERICA
3. Lightly tighten the manual control lever mounting nut (A) after installing the manual control lever (B).
   Fig 2: Locating Manual Control Lever And Mounting Nut

   Courtesy of HYUNDAI MOTOR AMERICA
4. Align the hole (A) in the manual control lever with the "N" position hole (B) of the inhibitor switch and then insert the inhibitor switch guide pin (SST No.: 09480-A3800).
   Fig 3: Inserting Inhibitor Switch Guide Pin (SST No.:09480-A3800)

   Courtesy of HYUNDAI MOTOR AMERICA
5. Tighten the bolts (B) after tightening the nut (A) with the specified torque.

   Tightening torque 

   (A) 17.7 ~ 24.5 N.m (1.8 ~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)

   (B) 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

   Fig 4: Locating Inhibitor Switch Bolts And Nut

   Courtesy of HYUNDAI MOTOR AMERICA
6. Connect the inhibitor switch connector (A).
7. Lightly tighten the nut (B) after connected the shift cable (C) in the manual control lever (D).
8. Push shift cable (C) lightly to "F" direction shown to eliminate free play of shift cable.
9. Tighten the nut (B) with the specified torque.

   Tightening torque: 

   9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)

   Fig 5: Pushing Shift Cable

   Courtesy of HYUNDAI MOTOR AMERICA
10. Remove the inhibitor switch guide pin (SST No.: 09480-A3800) from the hole.
    Fig 6: Removing Inhibitor Switch Guide Pin (SST No.:09480-A3800) From Hole

    Courtesy of HYUNDAI MOTOR AMERICA
11. Install the battery and battery tray.

    (Refer to Engine Electrical System - "BATTERY ")

12. Install the TCM.

    (Refer to Dual Clutch Transmission Control System - "TCM ")

13. Install the air cleaner and air duct.

(Refer to Engine Mechanical System - "AIR CLEANER ")