Items To Check

Inspect DTC code.
Inspect whether N setting matches.
- Adjust N setting
  (Refer to Automatic Transmission System - "INHIBITOR SWITCH ")
Inspect shift cable separation.
- Adjust shift cable separation
  (Refer to Automatic Transmission System - "SHIFT CABLE ")
Inspect whether connector is connected.
- Inspect connector thoroughly for looseness, poor connection, bending, corrosion, contamination, deformation, or damage.
- Turn ignition key "ON" and engine "OFF" and measure the power supplied to inhibitor switch circuit and voltage between ground.
  Specification: Approx. 12V
- Fix the pin wiring when connector pin wiring is faulty.
Inspect ground condition on reversing light circuit.
- Check the ground location of reversing light.
- Reattach reversing light if ground condition is faulty.
Inspect wiring connection on junction box power terminal and fuse lamp.
- Check whether fuse holder is separated and holder is holding the fuse tight.
  
  Fig 1: Inspecting Wiring Connection On Junction Box Power Terminal And Fuse Lamp
  Courtesy of HYUNDAI MOTOR AMERICA
- Attach tester fuse to check if it is connected appropriately.
  
  Fig 2: Attaching Tester Fuse To Ensure Proper Connection
  Courtesy of HYUNDAI MOTOR AMERICA
- Check whether fuse capacity is appropriate for each circuit.
- Check if fuse is damaged.
- Check pulling of fuse fixing wiring, inflow of foreign substance, and arrangement condition of terminal.
- Relocate the terminal that has been pulled and inspect using the method explained above.
- When problem is not solved, refer to the appropriate SYSTEMS WIRING DIAGRAM article to fix or replace the terminal.
Inspect inhibitor switch signal.
- Turn ignition key "ON" and engine "OFF".
- Measure the voltage between each terminal and chassis ground when shifting lever to "P, R, N, D" range.
  Specified Value:
  
  (Refer to Specification "Signal Code" Table - "SPECIFICATION ")