Repair Procedures: Installation
CAUTION:
[In The Case Of Installing Used ECM]
[In The Case Of Installing New ECM]
- When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure below.
[In The Case Of Installing Used ECM]
- Perform
"ECM Neutral Mode" procedure with GDS.
(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")
- After finishing "ECM Neutral Mode", perform
"Key Teaching" procedure with GDS.
(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")
[In The Case Of Installing New ECM]
- Perform
"Key teaching" procedure with GDS.
(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")
- Install in the reverse order of removal.
ECM Installation Bolt:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
ECM Bracket Installation Bolt:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)