LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2019 >> Accent SE, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 3) >> DTC P0113-00: Intake Air Temperature Sensor 1 Circuit High Input >> DTC Inspection >> Monitoring DTC Status
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Monitoring DTC Status

  1. Connect GDS to DLC (Data Link Cable).
  2. Warm up the engine to normal operating temperature.
  3. Monitor "IATS" parameter on the "Current Data" with GDS.
    G12593550Courtesy of HYUNDAI MOTOR AMERICA
  4. Are the parameters displayed correctly?

    YES 

    • This can be an intermittent fault caused by poor contact of the sensor's and/or ECM (PCM)'s connector. Or, ECM (PCM) memory was not cleared after repair. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace the relevant component (s) as necessary, and go to "Verification of Vehicle Repair ".

    NO 

scientia non olet · About LEMON Manuals