Component Inspection

1. Connect a GDS to DLC (Data Link Cable).
2. Turn the ignition switch ON.
3. Actuate the "ETC Motor" using the GDS.

   (During actuation, monitor the voltage of TPS (Throttle Position Sensor) 1 and 2 and the ETC motor duty on "Current Data.")

4. Does the actuation work properly? Is the sensor output normal?

Specification:  Refer to MONITOR GDS DATA 

YES 

• Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR ".

NO 

• Replace the TPS with an usable one and check for proper operation. If the problem is corrected, replace the TPS and then go to "VERIFICATION OF VEHICLE REPAIR ".