| DTC Strategy |
|
- Poor contact of connector
- Short to Battery or Open in TPS1 Signal Circuit
- Open in TPS Supply Circuit
- Faulty TPS1
|
| Enable Condition |
Case 1 |
|
| Case 2 |
- Ignition Switch "ON"
- Engine operating state idle:
- TPS set point is less than 61.098 deg.
- TPS 1 and TPS 2 ratio failure is detected or TPS 2 failure is detected
|
| Threshold Value |
Case 1 |
- The voltage of TPS 1 is greater than 4.9V
- Short circuit to battery or open circuit
|
| Case 2 |
- The voltage of TPS 1 at engine idle is greater than 3.0V
- Short circuit to battery or open circuit
|
| Diagnostic Time |
|
| MIL ON Condition |
|