LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2021 >> Santa Fe Limited, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 2.5T (Except HEV) >> Injector >> Repair Procedures >> Removal >> MPI Injector
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

MPI Injector

  1. Release the Residual Pressure in Fuel Line.

    (Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  3. Remove the engine cover.

    (Refer to Engine Mechanical System - "ENGINE COVER ")

  4. Disconnector the injector connector (A).
    G14537867Courtesy of HYUNDAI MOTOR AMERICA
  5. Disconnect the fuel delivery quick-connector (A).
  6. Remove the delivery pipe mounting bolt (B).

    Tightening torque:  18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.3 lb-ft)

    G14537868Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Open the clamp cover (A) before disconnecting the quick-connector. (If the clip is applied)
      G14537869Courtesy of HYUNDAI MOTOR AMERICA
    • When removing the quick-connector with the clip removing tool (A), be careful not to damage the plastic clip (B).
    • If the clip is damaged, it can cause a fuel leak due to bad connection and could result in a fire.
      G14537870Courtesy of HYUNDAI MOTOR AMERICA
  7. Release the fixing clip, and then separate the injector (A) from the delivery pipe.
    G14537871Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals