Repair Procedures: Removal

Perform the line pressure removal mode off procedure by using the diagnostic tool.

Courtesy of HYUNDAI MOTOR AMERICA
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the connector (A).

Courtesy of HYUNDAI MOTOR AMERICA
RCV solenoid valve hose (A) and then separate the intercooler outlet hose (B).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the TCM connector (A) and then loosening the TCM upper mounting bolts (B).
Tightening torque:

9.8 - 11.7 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.6 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
Remove the under cover.
(Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")
Remove the intercooler outlet hose (A).

Courtesy of HYUNDAI MOTOR AMERICA

Loosen the TCM bottom bolts and connector bolt (A) and then removing the TCM (B).

Tightening torque:

TCM bottom mounting bolts: 9.8 - 11.7 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.6 lb-ft)

TCM connector mounting bolt (A): 7.8 - 9.8 N.m (1.0 - 1.2 kgf.m, 5.8 - 7.2 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA

NOTE:

Be careful not to damage the TCM pin part (A) when removing the TCM assembly.

Courtesy of HYUNDAI MOTOR AMERICA