2. Check Steering Angle Sensor Circuit

1. Turn ignition switch OFF and disconnect VDC/TCS/ABS control unit connector and steering angle sensor connector.
2. Check continuity between VDC/TCS/ABS control unit harness connector E118 and steering angle sensor harness connector M22.
   Fig 1: Checking Continuity Between VDC/TCS/ABS Connector E118 And Connector M22

   Courtesy of NISSAN MOTOR CO., U.S.A.
   Fig 2: Steering Angle Sensor Circuit Continuity Reference

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

• OK: GO TO 3.
• NG: Open or short in harness. Repair or replace the suspect harness.