Display Item List
DISPLAY ITEM LIST
| Items (CONSULT-II screen terms) | Diagnostic item is detected when... | Check item |
|---|---|---|
| CONTROLLER FAILURE [C1201] |
Malfunction has occurred inside AWD control unit. | AWD CONTROL UNIT |
| ABS SYSTEM [C1203] |
Malfunction related to wheel sensor has been detected by ABS actuator and electric unit (control unit). | ABS SYSTEM |
| 4WD SOLENOID [C1204] |
Malfunction related to AWD solenoid has been detected. | AWD SOLENOID |
| 4WD ACTUATOR RLY [C1205] |
Malfunction has been detected from AWD actuator relay integrated with AWD control unit, or malfunction related to AWD solenoid has been detected. | AWD ACTUATOR RELAY or AWD SOLENOID |
| ENGINE SIGNAL 1 [C1210] |
Malfunction has been detected from ECM. | ENGINE CONTROL SIGNAL |
| CAN COMM CIRCUIT [U1000] |
Malfunction has been detected from CAN communication line. | CAN COMMUNICATION LINE |
| NO DTC IS DETECTED. FURTHER TESTING MAY BE REQUIRED. |
No NG item has been detected. | - |
CAUTION:
- If "CAN COMM CIRCUIT [U1000]" is displayed with other DTCs, first perform the TROUBLE DIAGNOSIS for CAN communication line.
- Make sure that ABS warning lamp turns OFF by driving for a minute at vehicle speed of 30 km/h (19 MPH) or more after turning ignition switch "OFF" if AWD warning lamp turns ON with system malfunction of "ABS SYSTEM [C1203]". AWD warning lamp may not turn OFF if it is normal unless ignition switch turns OFF at once and engine restarts after that.