LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2004 >> G35 x >> Repair and Diagnosis (Single Page) >> Transmission >> Transfer Case >> 2004.5 - Transfer - Sedan >> Trouble Diagnosis >> AWD Control Unit Input/Output Signal Reference Values AWD Control Unit Inspection Table >> Self-Diag Result Mode >> How To Erase Self-Diagnostic Results
April 5, 2026: LEMON Manuals is launched! Read the announcement.

How To Erase Self-Diagnostic Results

  1. Perform applicably inspection of malfunctioning item and then repair or replace.
  2. Start engine and drive at 30 km/h (19 MPH) or more for approx. 1 minute.
  3. Make sure that ABS warning lamp turns OFF.
    NOTE: Make sure that ABS warning lamp turns OFF by driving for a minute at vehicle speed of 30 km/h (19 MPH) or more after turning ignition switch "OFF" if AWD warning lamp turns ON with system malfunction of "ABS SYSTEM [C1203]". AWD warning lamp may not turn OFF if it is normal unless ignition switch turns OFF at once and engine restarts after that.
  4. Turn ignition switch "OFF" to erase memory.
  5. Start engine and select "SELF-DIAG RESULTS" mode for "ALL MODE AWD/4WD" with CONSULT-II.
  6. Touch "ERASE" on CONSULT-II screen to erase DTC memory.
    CAUTION: If memory cannot be erased, perform applicably diagnosis.
  7. Drive at 30 km/h (19 MPH) or more for approx. 1 minute. Be sure AWD warning lamp is OFF.
scientia non olet · About LEMON Manuals