Section 140 (2004.5 - Engine Control System - Introduction - Coupe)
WARNING: This page is about a different variant/trim than selected.
- Index For DTC
- Precautions
- Preparation
- Engine Control System
- System Diagram
- Vacuum Hose Drawing
- System Chart
- Multiport Fuel Injection (MFI) System
- Electronic Ignition (EI) System
- Air Conditioning Cut Control
- Fuel Cut Control (At No Load And High Engine Speed)
- CAN Communication
- Basic Service Procedure
- On Board Diagnostic (OBD) System
- Introduction
- Two Trip Detection Logic
- Emission-related Diagnostic Information
- Emission-Related Diagnostic Information Items
- DTC And 1ST Trip DTC
- How to Read DTC and 1st Trip DTC
- Freeze Frame Data And 1ST Trip Freeze Frame Data
- System Readiness Test (SRT) Code
- SRT Item
- SRT Set Timing
- SRT Service Procedure
- How to Display SRT Code
- How to Set SRT Code
- Driving Pattern
- Suggested Transmission Gear Position
- Suggested Upshift Speeds for M/T Models
- Suggested Maximum Speed in Each Gear
- Test Value And Test Limit (GST Only - Not Applicable To Consult-II)
- How To Erase Emission-Related Diagnostic Information
- IVIS (Infiniti Vehicle Immobilizer System - NATS)
- Malfunction Indicator Lamp (MIL)
- OBD System Operation Chart
- Relationship Between Mil, 1ST Trip DTC, DTC, And Detectable Items
- Summary Chart
- Relationship Between Mil, DTC, 1ST Trip DTC And Driving Patterns For "Misfire" < Exhaust Quality Deterioration >, "Fuel Injection System"
- Explanation For Driving Patterns For "Misfire < Exhaust Quality Deterioration >", "Fuel Injection System"
- Relationship Between Mil, DTC, 1ST Trip DTC And Driving Patterns Except For "Misfire < Exhaust Quality Deterioration >", "Fuel Injection System"
- Explanation For Driving Patterns Except For "Misfire < Exhaust Quality Deterioration >", "Fuel Injection System"
- Trouble Diagnosis
- Trouble Diagnosis Introduction
- DTC Inspection Priority Chart
- Fail-Safe Chart
- Basic Inspection
- Symptom Matrix Chart
- Engine Control Component Parts Location
- Circuit Diagram
- ECM Harness Connector Terminal Layout
- ECM Terminals and Reference Value
- CONSULT-II Function
- Generic Scan Tool (GST) Function
- CONSULT-II Reference Value in Data Monitor Mode
- Major Sensor Reference Graph in Data Monitor Mode
- Trouble Diagnosis - Specification Value
- Trouble Diagnosis For Intermittent Incident
- Power Supply And Ground Circuit