COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
DIAGNOSIS MODES AND FUNCTION DESCRIPTION
| Diagnosis mode | Function Description |
|---|---|
| Work Support | Changes the setting for each system function. |
| Self Diagnostic Result | Displays the diagnosis results judged by BCM. |
| CAN Diag Support Monitor | Monitors the reception status of CAN communication viewed from BCM. Refer to CONSULT-III operation manual . |
| Data Monitor | The BCM input/output signals are displayed. |
| Active Test | The signals used to activate each device are forcibly supplied from BCM. |
| ECU Identification | The BCM part number is displayed. |
| Configuration | This function is not used even though it is displayed. |
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system selection items.
SUB SYSTEM SELECTION ITEMS AND DIAGNOSIS MODES REFERENCE
| System | Sub system selection item | Diagnosis mode | ||||
|---|---|---|---|---|---|---|
| Work Support | Data Monitor | Active Test | ||||
| Door lock | DOOR LOCK | x | x | x | ||
| Rear window defogger | REAR DEFOGGER | x | x | |||
| Warning chime | BUZZER | x | x | |||
| Interior room lamp timer | INT LAMP | x | x | x | ||
| Exterior lamp | HEAD LAMP | x | x | x | ||
| Wiper and washer | WIPER | x | x | x | ||
| Turn signal and hazard warning lamps | FLASHER | x | x | x | ||
| Air conditioner(1) | AIR CONDITONER | x | ||||
| Intelligent Key system | INTELLIGENT KEY | x | x | x | ||
| Combination switch | COMB SW | x | ||||
| BCM | BCM | x | ||||
| IVIS - NATS | IMMU | x | x | |||
| Interior room lamp battery saver | BATTERY SAVER | x | x | x | ||
| Trunk open | TRUNK | x | ||||
| Vehicle security system | THEFT ALM | x | x | x | ||
| RAP system | RETAINED PWR | x | ||||
| Signal buffer system | SIGNAL BUFFER | x | x | |||
| TPMS | TPMS (AIR PRESSURE MONITOR) | x | x | x | ||
|
||||||