April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

CHECK CONTINUITY CAMERA IMAGE SIGNAL CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect camera control unit connector and front display unit connector.
3. Check continuity between camera control unit harness connector terminal 12 and display unit harness connector terminal 12.
  12 - 12 : Continuity should exist .
4. Check continuity between camera control unit harness connector terminal 12 and ground.
12 - Ground : Continuity should not exist .

Is the inspection result normal?

YES: GO TO 2.

NO: Repair harness or connector.

CHECK CAMERA IMAGE SIGNAL

Connect camera control unit connector and front display unit connector.
Turn ignition switch ON.
Check signal between camera control unit harness connector terminal 12 and ground.

TERMINAL VALUE REFERENCE

Terminal	Condition		Reference value
12 - Ground	Ignition switch ON	When rear view camera image is displayed.	Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal?

YES: Replace display unit.

NO: Replace camera control unit.