WITHOUT NAVIGATION : Diagnosis Procedure
- CHECK CONTINUITY RGB (R: RED) SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect front display unit connector and AV control unit connector.
- Check continuity between front display unit harness connector terminal 17 and AV control unit harness connector terminal 40.
17 - 40 : Continuity should exist .
- Check continuity between front display unit harness connector terminal 17 and ground.
17 - Ground : Continuity should not exist .
Is the inspection result normal?
YES: GO TO 2.
NO: Repair harness or connector.
- CHECK RGB (R: RED) SIGNAL
- Connect front display unit connector and AV control unit connector.
- Turn ignition switch ON.
- Check signal between front display unit harness connector terminal 17 and ground.
TERMINAL VALUE REFERENCETerminal Condition Reference value 17 - Ground Ignition switch ON Start confirmation/adjustment mode, and then display color bar by selecting "Color Spectrum Bar" on DISPLAY DIAGNOSIS screen. Is the inspection result normal?
YES: Replace display unit.
NO: Replace AV control unit.