Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

After the inspection is completed, clear the DTCs (see DTC CHECK/CLEAR ).

CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)

Enter the "Navigation Check" mode (Vehicle Sensors) (see NAVIGATION CHECK MODE ).

While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.

OK: The readings are almost equal.

Result

VEHICLE SENSOR (NAVIGATION CHECK MODE) RESULT CHART

Result	Proceed to
OK (for Column Shift Type)	A
OK (for Floor Shift Type)	B
NG	C

Fig 1: Diagnostic Tool Display - Vehicle Sensors Screen

B: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Column Shift Type) )

C: Go TO "SPEED SIGNAL DOES NOT CHANGE IN THE NAVIGATION CHECK MODE" IN PROBLEM SYMPTOMS TABLE )

A: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Column Shift Type) )