Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.

CHECK SELF DIAGNOSTIC RESULT 1
1. Select "Self Diagnostic Result" mode of "BCM" using CONSULT-III.
2. Erase DTC.
3. Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to , "DTC LOGIC ".
  Is DTC detected?
  
  YES: GO TO 2.
  
  NO: INSPECTION END
CHECK EQUIPMENT OF THE VEHICLE
Check that unspecified accessory part related to engine start is not installed.

Is unspecified accessory part related to engine start installed?

YES: GO TO 3.

NO: GO TO 4.
CHECK SELF DIAGNOSTIC RESULT 2
1. Obtain the customers approval to remove unspecified accessory part related to engine start, and then remove it.
2. Select "Self Diagnostic Result" of "BCM" using CONSULT-III.
3. Erase DTC.
4. Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to , "DTC LOGIC ".
  Is DTC detected?
  
  YES: GO TO 4.
  
  NO: INSPECTION END
REPLACE BCM
1. Replace BCM. Refer to "REMOVAL AND INSTALLATION ".
2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.
  For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.
  
  INSPECTION END