Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DTC OF IPDM E/R
Check DTC in "Self Diagnostic Result" mode of "IPDM E/R" using CONSULT-III.

Is DTC detected?

YES: Perform the trouble diagnosis related to the detected DTC. Refer to "DTC INDEX ".

NO: GO TO 2.

CHECK STARTER RELAY CIRCUIT

Turn ignition switch OFF.
Disconnect IPDM E/R connector.
Disconnect BCM connector.

Check continuity between IPDM E/R harness connector and BCM harness connector.

CONNECTOR TERMINALS CONTINUITY REFERENCE CHART

IPDM E/R		BCM		Continuity
Connector	Terminal	Connector	Terminal	Continuity
E13	30	M70	97	Existed

Check continuity between IPDM E/R harness connector and ground.

CONNECTOR TERMINALS CONTINUITY REFERENCE CHART

IPDM E/R		Ground	Continuity
Connector	Terminal
E13	30		Not existed

Is the inspection result normal?

YES: GO TO 3.

NO: Repair or replace harness.

REPLACE IPDM E/R
1. Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION ".
2. Perform DTC CONFIRMATION PROCEDURE for DTC B2608. Refer to , "DTC LOGIC ".
  Is DTC B2608 detected again?
  
  YES: INSPECTION END
  
  NO: GO TO 4.
REPLACE BCM
1. Replace BCM. Refer to "REMOVAL AND INSTALLATION ".
2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.
  For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.
  
  INSPECTION END