Calibrating Camera Image
- Perform the calibration of camera image caused by the incorrect mounting position of each camera, etc. Always perform calibration after performing the following work.
- When each camera or each camera mount (door mirror, front grille, etc.) is removed
- When replacing around view monitor control unit
- When performing the calibration initialization, it can be set to the NISSAN factory shipment condition.
Refer to "CALIBRATING CAMERA IMAGE (AROUND VIEW MONITOR) : WORK PROCEDURE " for the calibration procedure.
Adjustment range
Rotating direction : 31 patterns (16 on the center)
Upper/lower direction : -99 - 99
Left/right direction : -99 - 99
Calibrating Camera Image item
ITEM DESCRIPTION
| Items | Description | ||
|---|---|---|---|
| Rear Camera | Performs the calibration of rear camera. | ||
| Pass-Side Camera | Performs the calibration of side camera RH. | ||
| Front Camera | Performs the calibration of front camera. | ||
| Dr-Side Camera | Performs the calibration of side camera LH. | ||
| Initialize Camera Image Calibration(1) | The calibration can be initialized to the factory shipment setting. | ||
|
|||
Fine Tuning of Birds-Eye View
- The fine adjustment function of camera calibration can check and adjust the difference between each camera.
- Fine adjustments can be performed for each camera. Move the "+"-mark to select the camera by pressing the "CAMERA" switch.
- Perform the adjustment with the center dial and upper/lower/left/right switches.
CAUTION:
Operate the center dial slowly because the changing of the screen takes approximately 1 second.
NOTE:
- It can be initialized to the NISSAN factory shipment setting with "Initialize Camera Image Calibration" of "Calibrating Camera Image".
- The adjustment value is cancelled in this mode by performing "Initialize Camera Image Calibration".
Adjustment range
Rotating direction : 31 patterns (16 on the center)
Upper/lower direction : -99 - 99
Left/right direction : -99 - 99
ZOOM function
- The ZOOM ratio of camera can be changed when calibrating the camera.
- It shifts to ZOOM function mode by shifting the selector lever to a position other than the "R" position → "R" position → other than "R" position in the "Fine Tuning of Birds-Eye View" mode.
- The changing of ZOOM ratio can be performed for each camera. Move the "+"-mark to select the camera by pressing "CAMERA" switch and press the left/right switch to change the ZOOM ratio.NOTE:
- When the position is not correct in "Fine Tuning of Birds-Eye View" mode, use this "ZOOM" function to adjust it.
- If this function is used, always adjust the upper/lower/left/right position again on the "Fine Tuning of Birds-Eye View" screen.
Correct Draw Line of Wide View
The display position of guiding lines when displayed on the rear-wide view can be changed.
Adjustment range
Rotating direction : 7 patterns
Correct Draw Line of Camera Image item
CORRECT DRAW LINE OF CAMERA IMAGE ITEM
| Items | Description |
|---|---|
| Rear-Wide View | The position of rear wide view guideline can be changed. |