ZOOM function

• The ZOOM ratio of camera can be changed when calibrating the camera.
• It shifts to ZOOM function mode by shifting the selector lever to a position other than the "R" position → "R" position → other than "R" position in the "Fine Tuning of Birds-Eye View" mode.
• The changing of ZOOM ratio can be performed for each camera. Move the "+"-mark to select the camera by pressing "CAMERA" switch and press the left/right switch to change the ZOOM ratio.
  NOTE:

  • When the position is not correct in "Fine Tuning of Birds-Eye View" mode, use this "ZOOM" function to adjust it.
  • If this function is used, always adjust the upper/lower/left/right position again on the "Fine Tuning of Birds-Eye View" screen.
  Fig 1: Display Zoom Function

  Courtesy of NISSAN MOTOR CO., U.S.A.

Correct Draw Line of Wide View 

The display position of guiding lines when displayed on the rear-wide view can be changed.

Fig 2: Display Position Of Guiding Lines

Courtesy of NISSAN MOTOR CO., U.S.A.

Correct Draw Line of Camera Image item