Active Test Mode
Description
- 4WAS rear actuator assembly activation is checked according to the control signal from CONSULT-III.
- The control signal forcibly activates (ON/OFF) 4WAS rear assembly, performs the self-diagnosis and checks each sensor in "SELF DIAGNOSTIC MODE".CAUTION: Perform the active test while the vehicle is stopped.
CONTROL SIGNAL REFERENCE CHART
| Select test item | Control signal | Remarks |
|---|---|---|
| SELF DIAGNOSTIC MODE | ON
CAUTION:
Perform the active test while the vehicle is stopped.
|
4WAS rear actuator assembly activates. It activates in the same direction as the steering angle by inputting the steering angle. |
| OFF | 4WAS rear actuator assembly stops the activation. |
Standard value
MONITOR ITEMS REFERENCE CHART
| Monitor item | Active test "ON" | ||
|---|---|---|---|
| STEERING ANG | 0° (Neutral) | R 90° | L 90° |
| RR ST ANG-MAI | 2.4 V | Approx. 4.4 V | Approx. 0.4 V |
| RR ST ANG-SUB | 2.4 V | Approx. 4.4 V | Approx. 0.4 V |
| MOTOR CURRENT | No output (Approx. 0 A) | Output (change) | |