COMMON ITEM: CONSULT Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT performs the following functions via CAN communication with BCM.
| Diagnosis mode | Function Description |
|---|---|
| Work Support | Changes the setting for each system function. |
| Self Diagnostic Result | Displays the diagnosis results judged by BCM. |
| CAN Diag Support Monitor | Monitors the reception status of CAN communication viewed from BCM. |
| Data Monitor | The BCM input/output signals are displayed. |
| Active Test | The signals used to activate each device are forcibly supplied from BCM. |
| ECU Identification | The BCM part number is displayed. |
| Configuration | This function is not used even though it is displayed. |
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system selection items.
| x: Applicable item | ||||||||
|---|---|---|---|---|---|---|---|---|
| System | Sub system selection item | Diagnosis mode | ||||||
| Work Support | Data Monitor | Active Test | ||||||
| Door lock | DOOR LOCK | x | x | x | ||||
| Rear window defogger | REAR DEFOGGER | - | x | x | ||||
| Warning chime | BUZZER | - | x | x | ||||
| Interior room lamp timer | INT LAMP | x | x | x | ||||
| - | MULTI REMOTE ENT(1) | - | - | - | ||||
| Exterior lamp | HEAD LAMP | x | x | x | ||||
| Wiper and washer | WIPER | x(2) | x | x | ||||
| Turn signal and hazard warning lamps | FLASHER | x | x | x | ||||
| - | AIR CONDITONER(1) | - | - | - | ||||
|
INTELLIGENT KEY | x | x | x | ||||
| Combination switch | COMB SW | - | x | - | ||||
| Body control system | BCM | x | - | - | ||||
| IVIS - NATS | IMMU | - | x | x | ||||
| Interior room lamp battery saver | BATTERY SAVER | x | x | x | ||||
| Trunk lid open | TRUNK | - | x | x | ||||
| Vehicle security system | THEFT ALM | x | x | x | ||||
| RAP system | RETAINED PWR | - | x | - | ||||
| Signal buffer system | SIGNAL BUFFER | - | x | x | ||||
| TPMS | AIR PRESSURE MONITOR | x | x | x | ||||
|
||||||||