Work Procedure

CAUTION: Be careful of traffic conditions and safety around the vehicle when performing road test.

NOTE: Fully understand the following items well before the road test;

LDW/LDP SYSTEM ACTION TEST
Perform the LDW/LDP system action test. Refer to "INSPECTION PROCEDURE ".

: GO TO 2.
CHECK BSW SYSTEM SETTING
1. Set the vehicle to READY.
2. Check that the BSW system setting can be enabled/disabled on the navigation screen.
3. Turn OFF the ignition switch and wait for 5 seconds or more.
4. Check that the previous setting is saved when the vehicle is set in the READY state again.
  : GO TO 3.

BSW SYSTEM ACTION TEST

Enable the setting of the BSW system on the navigation screen.
Turn warning systems switch ON (warning systems ON indicator is ON).
NOTE: BSI system is OFF.

Check BSW operation according to the following table.

Vehicle condition/Driver's operation				Action
Warning systems ON indicator	Vehicle speed (Approx.) [km/h (MPH)]	Turn signal condition	Status of vehicle detection within detection area	Indication on the BSW/BSI indicator	Buzzer
OFF	-	-	-	OFF	OFF
ON	Less than approx. 29 (18)	-	-	OFF	OFF
	Approx. 32 (20) or more	-	Vehicle is absent	OFF	OFF
		OFF	Vehicle is detected	ON	OFF
		ON (Vehicle detected direction)	Before turn signal operates Vehicle is detected	Blink	Short continuous beep
		ON (Vehicle detected direction)	Vehicle is detected after turn signal operates	Blink	OFF

NOTE:

If vehicle speed exceeds approximately 32 km/h (20MPH), BSW function operates until the vehicle speed becomes lower than approximately 29km/h (18MPH).
Time shown in the figure is approximate time.
Always BSI system operates together with BSW system. Whenever BSI system is turned on by pushing the dynamic driver assistance switch, BSW system also be turned on even if the BSW system is turned off. However, at this time the warning systems ON indicator remains OFF.

: GO TO 4.