Work Procedure

WARNING: This page is about a different car, the 2013 Infiniti M56 and 2013 Infiniti M37. However, it is still accessible from the selected car via links, so may be relevant.

WRITING MODE SELECTION
CONSULT Configuration

Select "Re/programming, Configuration" of CAN gateway.

When writing saved data: GO TO 2.

When writing manually: GO TO 3.
PERFORM "AFTER REPLACE ECU" OF "READ/WRITE CONFIGURATION"
CONSULT Configuration

Perform "After Replace ECU" of "Read/Write Configuration".

: GO TO 4.
PERFORM "MANUAL CONFIGURATION"
CONSULT Configuration
1. Select "Manual Configuration".
2. Touch "Next".
3. Touch "OK".
4. Check that the configuration has been successfully written and touch "End".
  : GO TO 4.
CHECK ALL ECU SELF-DIAGNOSIS RESULTS
1. Erase all ECU self-diagnosis results using CONSULT.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON and wait for 2 seconds or more.
4. Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.
  : WORK END