Diagnostic Test

1. Turn the Ignition Switch OFF.
2. Disconnect Chassis Control Module harness connector.
3. Check the voltage between Chassis Control Module harness connector and ground.

   +		-	Voltage (Approx.)
   Chassis Control Module
   Connector	Terminal
   E219	4	Ground	0 V
   	25

4. Turn the Ignition Switch ON.
   CAUTION:

   Never start engine.

5. Check the voltage between Chassis Control Module harness connector and ground.

   +		-	Voltage (Approx.)
   Chassis Control Module
   Connector	Terminal
   E219	4	Ground	6.4 - 16 V
   	25

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

GO TO STEP 2  .

1. Turn the Ignition Switch OFF.
2. Check the 5 A fuse (No. 21).
3. Check the 5 A fuse (No. 23).
4. Disconnect fuse block (J/B) harness connector.
5. Check the continuity between Chassis Control Module harness connector and fuse block (J/B) harness connector.

   Chassis Control Module		Fuse Block (J/B)		Continuity
   Connector	Terminal	Connector	Terminal
   E219	4	E64	7E	Existed
   	25	M132	14B

6. Check the continuity between Chassis Control Module harness connector and the ground.

   Chassis Control Module		-	Continuity
   Connector	Terminal
   E219	4	Ground	Not existed
   	25

Is the inspection result normal?

YES 

Perform trouble diagnosis for ignition power supply.

NO 

Repair or replace error-detected parts.

1. Turn the Ignition Switch OFF.
2. Check the continuity between Chassis Control Module harness connector and ground.

   Chassis Control Module		-	Continuity
   Connector	Terminal
   E219	6	Ground	Existed
   	23

Is the inspection result normal?

YES 

GO TO STEP 4  .

NO 

Repair or replace error-detected parts.

Check the Chassis Control Module pin terminals for damage or loose connection with harness connector.

Is the inspection result normal?

YES 

INSPECTION END

NO 

Repair or replace error-detected parts.