Inspection Procedure

1. Start the engine.
2. Check that the Active Lane Control setting can be enabled/disabled on the integral switch screen.
3. Turn OFF the Ignition Switch and wait for 30 seconds or more.
4. Check that the previous setting is saved when the engine starts again.

GO TO STEP 2  .

1. Enable the setting of the Active Lane Control on the integral switch screen.
2. Enable the setting of the "Chassis Control" display in the vehicle information display on the integral switch screen.
3. Select the "Chassis Control" display on the vehicle information display.
4. Turn dynamic driver assistance switch ON (LDP system is ON).
5. Check that the Active Lane Control operating according to the following table.
   NOTE:

   For the operating conditions, refer to SYSTEM DESCRIPTION .

   Vehicle condition	Active Lane Control	Indication On The Combination Meter
   -	OFF	Courtesy of NISSAN NORTH AMERICA, INC.
   Operating conditions are not satisfied	Active Lane Control is turned ON	Courtesy of NISSAN NORTH AMERICA, INC.
   Operating conditions are satisfied	Active Lane Control is operational or is operating	Courtesy of NISSAN NORTH AMERICA, INC.

Does it operate normally?

YES 

INSPECTION END

NO 

Perform symptom diagnosis. Specify malfunctioning part. Refer to SYMPTOM TABLE .