DTC Confirmation Procedure

Will CONSULT be used?

Will CONSULT be used?

YES 

GO TO STEP 2  .

NO 

GO TO STEP  5.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

GO TO STEP 3  .

WITH CONSULT

1. Turn ignition switch ON.
2. Select "P/N POSI SW" in "DATA MONITOR" mode with CONSULT. Then check the "P/N POSI SW" signal under the following conditions.

   Position (Selector lever)	Known-good signal
   N or P position	ON
   Except above position	OFF

Is the inspection result normal?

YES 

GO TO STEP 4  .

NO 

Go to DIAGNOSIS PROCEDURE .

1. Select "DATA MONITOR" mode with CONSULT.
2. Start engine and warm it up to normal operating temperature.
3. Maintain the following conditions for at least 50 consecutive seconds.
   CAUTION:

   Always drive vehicle at a safe speed.

   FOR USA AND CANADA
   
   

   ENG SPEED	1, 000 - 6, 375 rpm
   COOLAN TEMP/S	More than 67°C (152.6°F)
   B/FUEL SCHDL	2.0 - 31.8 msec
   VHCL SPEED SE	More than 64 km/h (40 mph)
   Selector lever	Suitable position

   EXCEPT FOR USA AND CANADA
   
   

   ENG SPEED	1, 000 - 6, 375 rpm
   COOLAN TEMP/S	More than 60°C (140°F)
   B/FUEL SCHDL	2.0 - 31.8 msec
   VHCL SPEED SE	More than 64 km/h (40 mph)
   Selector lever	Suitable position

4. Check 1st trip DTC.

Is 1st trip DTC detected?

YES 

Go to DIAGNOSIS PROCEDURE .

NO 

INSPECTION END

WITH GST

Perform Component Function Check. Refer to COMPONENT FUNCTION CHECK .

Is the inspection result normal?

YES 

INSPECTION END

NO 

Go to DIAGNOSIS PROCEDURE .