Work Procedure: FPCM

With CONSULT

1. Turn ignition switch ON.
2. Select the "Re/programming, Configuration" of CONSULT.
3. Perform configuration according to the CONSULT display.

GO TO 2.

CONSULT Configuration

Select "CONFIGURATION" of FSCM.

When writing saved data

GO TO 3.

CONSULT Configuration

Select "Before ECU Replacement". (If necessary)

GO TO 4.

CONSULT Configuration

Perform "Before ECU Replacement" according to the CONSULT display. (If necessary)

GO TO 5.

With CONSULT

1. Turn ignition switch ON.
2. Select the "Re/programming, Configuration" of CONSULT.
3. Select the "After ECU Replacement".
4. Select the "Manual Configuration". (If necessary)
5. Confirm and/or change setting value for each item.
6. Perform configuration according to the CONSULT display.

GO TO 6.

With CONSULT

1. Turn ignition switch OFF and wait for 10 seconds or more.
2. Turn ignition switch ON.
3. Perform self-diagnosis.
4. Check that no DTC is detected.

WORK END