Values On The Diagnosis Tool

WARNING: This page is about a different variant/trim than selected.

NOTE: The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor item	Condition	Value/Status
Voltage	Always	11 - 15.5 V
POWER SUPPLY	Always	11 - 15.5 V
Status of solenoid valve	Diagnosis initialize	Diag init
	Inactive no valid information	Ia no vld
	Inactive short to ground	Ia sh gnd
	Inactive short to power supply	Ia sh pwr
	Inactive open load	Ia op ld
	Inactive no malfunction	Ia no mlf
	Active no valid information	Ac no vld
	Active electrical malfunction	Ac el mlf
	Active no malfunction	Ac no mlf
Resistance of solenoid valve	Ignition switch: ON	4.3 - 4.9 ohm
MAIN ODOMETER READING	Always	Nearly matches the odometer display
Current thermal load of sv	Vehicle running	0 - 90%
Status of control unit	No state	No state
	Initialize component	Init comp
	Normal operation	Normal Operation
	Components run	Cmp run
	Not defined	Not defined
	Shutdown components	Sd comp
	Ready for shutdown	Rdy fr sd
	Error	Error: Error
	Temporary error	Temp err
	Permanent error	Prmnt err
	Idle	Idle
	Off	OFF
Distance driven snc lst oil cng	Always	Distance driven since last oil change
Clutch work range 1	--	-- ^*
Clutch work range 2	--	-- ^*
Clutch work range 3	--	-- ^*
Gear efficiency	--	-- ^*
Drag loss	--	-- ^*
Oil work	--	-- ^*

*: The values are changed by depressed accelerator pedal opening, engine speed, and driving condition.