Component Inspection
- CHECK CAMSHAFT POSITION SENSOR-I
- Turn ignition switch OFF.
- Loosen the fixing bolt of the sensor.
- Disconnect camshaft position sensor harness connector.
- Remove the sensor. Refer to CAMSHAFT : Exploded View .
- Visually check the sensor for chipping.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Replace malfunctioning camshaft position sensor. Refer to CAMSHAFT : Exploded View .
- CHECK CAMSHAFT POSITION SENSOR-II
Check resistance camshaft position sensor terminals as follows.
Terminals (Polarity) Resistance (Ω) 1 (+) - 2 (-) Except 0 or ∞ [at 25°C (77°F)] 1 (+) - 3 (-) 2 (+) - 3 (-) Is the inspection result normal?
YES>>
INSPECTION END
NO>>
Replace malfunctioning camshaft position sensor. Refer to CAMSHAFT : Exploded View .