LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 1996 >> Rodeo LS, 2.6 E >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.6L 4-CYL >> Circuit Testing >> DTC P0336 - CKP Sensor Circuit 58X Reference Signal >> Diagnostic Procedures
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedures

  1. Perform ON-Board Diagnostic (OBD) System Check. Read and record FREEZE FRAME and/or FAIL RECORDS data for each DTC set. Go to next step.
  2. Attempt to start engine. If engine starts and runs, go to next step. If engine does not start and run, see ENGINE DOES NOT START in BASIC TESTING - 2.6L 4-CYL article.
  3. Using scan tool, clear DTC P0336. Start engine and allow it to idle for one minute. Read DTCs. If DTC P0336 resets, go to next step. If DTC does not reset, go to DIAGNOSTIC AIDS.
  4. Disconnect PCM and CMP sensor connector. Check for an open or a short to ground in 58X reference circuit between CKP sensor connector and PCM harness connector. If a problem is found, repair as necessary and go to step 10. If no problem is found, go to next step.
  5. Reconnect PCM and CKP sensor. Using a DVOM measure voltage on 58X reference circuit at PCM connector while cranking engine. If DVOM reads around 2.5 volts, go to step 8). If voltage is not as specified, go to next step.
  6. Check for faulty connections at CKP sensor. If a faulty connection is found, repair as necessary and go to step 10). If connections are okay, go to next step.
  7. Replace CKP sensor and go to step 10).
  8. Check for faulty connections at PCM. If a faulty connection is found, repair as necessary and go to step 10). If connections are okay, go to next step.
  9. Replace PCM. Program replacement PCM using required equipment. Go to next step.
  10. Read and record FAIL RECORDS data for DTC P0336. Operate vehicle within conditions noted in FAIL RECORDS data. Using scan tool, read SPECIFIC DTC. If scan tool displays DTC P0336 FAILED THIS IGN, return to step 2). If scan tool does not display DTC P0336 FAILED THIS IGN, repair is complete.
scientia non olet · About LEMON Manuals