Programming and Relearning

EEPROM Programming
1. Step-up - Ensure that the following conditions have been met:
- The battery is fully charged.
- The ignition is ON.
- The Vehicle Interface Module cable connection at the DLC is secure.

2. Program the PCM using the latest software matching the vehicle. Refer to up-to-date Techline equipment user's instructions.

3. If the PCM fails to program proceed as follows:
- Ensure that all PCM connections are OK.
- Check the Techline equipment for the latest software version.
- Attempt to program the PCM. If the PCM still cannot be programmed properly replace the PCM. The replacement PCM must be programmed.

Functional Check
1. Perform the On-Board Diagnostic System Check.
2. Start the engine and run for one minute.
3. Scan for DTCs using the scan tool.