LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2000 >> Hombre S, 2.2 4, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics - 2.2L >> Programming >> Crankshaft Position (CKP) Sensor Variation Learn Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position (CKP) Sensor Variation Learn Procedure

  1. Procedure must be performed if any of the following have been done:
    • EEPROM was reprogrammed.
    • Crankshaft position sensor was removed or replaced.
    • Vehicle Control Module (VCM) was replaced.
    • Repair was performed that disturbs crankshaft/harmonic balancer to crankshaft position sensor relationship.
  2. Connect scan tool to Data Link Connector (DLC). Apply parking brake. Block rear wheels. Ensure hood is closed.
  3. Place transmission in Park (A/T models) or Neutral (M/T models). Start engine and warm engine until engine coolant temperature is at least 185°F (85°C). Ensure all accessories are off.
  4. Apply service brakes. With engine idling, use scan tool to select and enable CKP sensor variation learn procedure.
  5. Gradually accelerate engine to 4000 RPM. Quickly release throttle to idle position once CKP sensor variation learn procedure is obtained and engine starts to decelerate (cut-out). Once CKP sensor variation values are learned, the VCM will return engine control to the operator and engine will respond to throttle position.
    CAUTION: Ensure throttle is quickly released to idle position once CKP sensor variation learn procedure fuel cut off is obtained and engine starts to decelerate.
  6. If CKP sensor variation learn procedure was completed, turn ignition off for at least 15 seconds and remove scan tool. If CKP sensor variation learn procedure was not completed, a DTC P1336 should be stored in the VCM. Perform test procedures for DTC P1336: CKP SYSTEM VARIATION NOT LEARNED  and repair as necessary. See DIAGNOSTIC TESTS .
scientia non olet · About LEMON Manuals