Throttle Actuator Control Module (Ascender 5.3L): Installation

1. If necessary, install the TAC module bracket (1) and nuts (2). Tighten the nuts to specification. See TORQUE SPECIFICATIONS  . See Fig 3 .
2. Install TAC module (3) to retaining bracket (1).
3. Snap TAC module (3) into retaining tab.
4. Connect engine electrical connector. See Fig 2 .
5. Connect I/P electrical connector. See Fig 1 .
6. Install bulk connector to bracket.

Fig 1: Locating Instrument Panel Electrical Connector (Ascender 5.3L)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Connecting & Disconnecting Electrical Connector At Throttle Actuator Control Module (Ascender 5.3L)

Courtesy of GENERAL MOTORS CORP.

Fig 3: Removing & Installing Throttle Actuator Control Module (Ascender 5.3L)

Courtesy of GENERAL MOTORS CORP.