Test Description

The numbers below refer to the step numbers in the diagnostic procedures.

1. 2 -  In this step visually and physically inspect damage to throttle valve assembly.
2. 3 -  In this step visually and physically inspect damage to accelerator pedal assembly.
3. 5 -  Check throttle valve and throttle valve motor resistance. Check TPS resistance. See THROTTLE POSITION SENSOR RESISTANCE  table.
4. 7 -  Check Accelerator Pedal Sensor (APS) resistance. See ACCELERATOR POSITION SENSOR  table.
   THROTTLE POSITION SENSOR RESISTANCE
   
   

   TPS No. 1 Measure Between Pins		Specification (Ohms)
   Throttle Position Sensor No. 1
   No. 1 (Green wire) & No. 5 (Red wire)		1000-7000
   No. 1 (Green wire) & No. 6 (Blue wire)		(1)
   Throttle Position Sensor No. 2
   No. 4 (Green/White wire) & No. 8 (Red/White wire)		1000-7000
   No. 4 (Blue/White wire) & No. 7 (Blue/White wire)		(1)
   (1) Resistance should change from .3-100 ohms as throttle is moved from closed throttle to wide open throttle.

   ACCELERATION POSITION SENSOR RESISTANCE
   
   

   APS No. 1 Measure Between Pins		Specification (Ohms)
   APS No. 1
   No. 10 (Black wire) & No. 4 (Red wire)		4-6
   No. 4 (Red wire) & No. 5 (White wire)		(1)
   APS No. 2
   No. 3 (Blue wire) & No. 8 (Green wire)		4-6
   No. 3 (Blue wire) & No. 9 (Yellow wire)		(1)
   APS No. 3
   No. 1 (Orange wire) & No. 7 (Orange/Blue wire)		4-6
   No. 6 (Blue/Green wire) & No. 7 (Orange/Blue wire)		(1)
   (1) Resistance should change smoothly and steadily as accelerator pedal is pressed.