Installation Procedure

Fig 1: View Of Air Filter Housing/Washer Solvent Tank Assembly & Washer Pump Hoses

Courtesy of GENERAL MOTORS CORP.

Install the lower air filter housing/washer solvent tank assembly (2) onto the mounting studs.
Connect the washer pump hoses (3) to the washer pumps.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 air cleaner housing/washer solvent tank assembly retaining nuts (1) to the mounting studs.
Tighten: Tighten the nuts to 15 N.m (11 lb ft).

Fig 2: View Of Washer Hose

Courtesy of GENERAL MOTORS CORP.

If applicable, connect the headlamp washer hose to the headlamp washer pump located on the lower air cleaner housing/washer solvent tank.

Fig 3: View Of Washer Pump Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the following electrical connectors:
- Windshield washer pump (1)
- Headlamp washer pump (2), if equipped
- Low solvent level sensor (4)
- Lift gate washer pump (6), if equipped
Install the washer solvent level sensor wire harness to the wire harness retaining clips (3, 5).

Fig 4: Exploded View Of Air Cleaner Assembly

Courtesy of GENERAL MOTORS CORP.

Install the air cleaner cover (2), the filter element (6), the mass air flow (MAF)/intake air temperature (IAT) sensor (3), and the air inlet duct (5) to the lower air cleaner housing/washer solvent tank assembly (4). Refer to Air Cleaner Element Replacement .